How to set a boat anchor in 3 simple steps

 Step 1: Choosing your location

It's important to make sure that you are far enough away from shallow waters and any potential hazards that your boat could drift in to while anchored. You also need to make sure that there are no hazards in the entire turning circle of the boat.

Once you are happy with your boat's location then it's time to drop the anchor.

Step 2: Dropping the anchor

An easy mistake to make is to just throw your anchor and line over the side. This can cause issues with the anchor getting tangled in the line/chain and not laying correctly on the ocean floor.

You should carefully drop your anchor straight down and feed the line until you see or feel the anchor hit the bottom.

Once the anchor is resting correctly on the bottom, it's time to set the anchor.

Step 3: Setting the anchor

To set the anchor, give out some scope (surplus anchor line) and then hold the line on a cleat and let the anchor start biting on the seabed as the boat drifts back on the current. Gradually continue to pay out more scope until you feel the anchor bite and hold.

Your anchor should embed itself in the ocean floor, give to a hard tug to ensure that it is set. An anchor being set means it's completely stuck.

Once you're happy that the anchor is set, tie the anchor line off on a cleat and you're ready to enjoy the waters!

How much scope should I let out?

A safe rule of thumb for the quantity of line to scope depends on whether you are using a rope or chain line.

For chains, you want to ideally have three times the depth of water for the chain. So in 5 metres of water, you will want 15 metres of scope.

For rope lines, a good rule of thumb is five times the depth of water. So for 5 meters of water, you will want 25 metres of scope.